• Size: 99.5 x 22 x 18mm
  • Capacity: 2.8 ml • Coil Resistance: 0.6 Ω & 1.0 Ω
  • Output Power: 10w – 22W
  • Output Voltage: 3.3 – 4.2V
  • Material: TPE + PCTG
  • Battery Capacity: 1000 mAh

The Nevoks Feelin 2 Kit is a chic and sophisticated pod kit suitable for both new and seasoned vapers. Boasting an 1100mAh battery and a power range of 10-30W, this kit caters to a variety of vaping styles, including Mouth-to-Lung (MTL), Restricted Direct-to-Lung (RDL), and Direct-to-Lung (DTL) preferences. The kit is equipped with a single button that conveniently serves the dual purpose of locking and unlocking the device. Once unlocked, initiating a vaping session is as simple as inhaling through the mouthpiece or pressing and holding the button to activate the device.

Package Includes:

  • 1x Feelin Battery
  • 1x Feelin Empty Pod 2.8ml
  • 1x SPL-10 Mesh Coil 0.6ohm
  • 1x SPL-10 Mesh Coil 1.0ohm
  • 1x Type-C Cable
  • 1x User Manual
  • 1x Warranty Card

Using the Nevoks Feelin 2 pod kit
Fill with e-liquid. Remove the silicone plug on the pod’s side and insert the nozzle to fill.
Powering the device ON. Press the button 5 times in the power-off state until the RGB LED flashes from red to green.
Vaping: Auto-Draw or Power Button. The RGB LED will gradually light up and fade out as you use the vape.
Powering the device OFF. Press the button 5 times in the power-off state until the RGB LED flashes from green to blue to red.
Auto standby. When the device is powered on, the power button will enter standby mode after 1 minute of no activity. The device will switch to draw activation mode until the first puff, this will activate the power button again.
Power levels and charging. The RGB LED will indicate the power level by dropping from Green to Blue to Red, with Red being the lowest. When fully charged the LED will remain Green. The Nevoks Feelin 2 has a pass-through charging port, allowing the device to be used whilst charging.


There are no reviews yet.

Be the first to review “NEVOKS FEELIN 2 POD KIT”

Your email address will not be published. Required fields are marked *